ATTINY13A-PU Microcontroller

The device achieves up to 20 MIPS throughput at 20 MHz at 1.8-5.5 V operation.

ATTINY13A-PU Microcontroller is  Atmel's picoPower 8-bit AVR RISC-based microcontroller featuring 1KB of ISP Flash, 64-byte EEPROM, 64-byte SRAM, 32-Byte register file, and 4-channel 10-bit A/D converter. 
By executing powerful instructions in a single clock cycle, the ATtiny13A achieves through puts approaching 1 MIPS per MHz allowing you to optimize power consumption versus processing speed.

Features of ATTiny13A-PU

High Performance, Low Power AVR® 8-Bit Microcontroller

• Advanced RISC Architecture

          – 120 Powerful Instructions – Most Single Clock Cycle Execution

          – 32 x 8 General Purpose Working Registers

          – Fully Static Operation

          – Up to 20 MIPS Througput at 20 MHz

• High Endurance Non-volatile Memory segments

          – 1K Bytes of In-System Self-programmable Flash program memory

          – 64 Bytes EEPROM

          – 64 Bytes Internal SRAM

          – Write/Erase Cycles : 10,000 Flash/100,000 EEPROM

          – Data retention : 20 Years at 85°C/100 Years at 25°C (see page 6)

          – Programming Lock for Self-Programming Flash & EEPROM Data Security

Peripheral Features

• One 8-bit Timer/Counter with Prescaler and Two PWM Channels

• 4-channel, 10-bit ADC with Internal Voltage Reference

• Programmable Watchdog Timer with Separate On-chip Oscillator

• On-chip Analog Comparator

Special Microcontroller Features

• debug WIRE On-chip Debug System

• In-System Programmable via SPI Port

• External and Internal Interrupt Sources

• Low Power Idle, ADC Noise Reduction, and Power-down Modes

• Enhanced Power-on Reset Circuit

• Programmable Brown-out Detection Circuit with Software Disable Function

• Internal Calibrated Oscillator

I/O and Packages

• 8-pin PDIP/SOIC : Six Programmable I/O Lines

• 10-pad MLF : Six Programmable I/O Lines

• 20-pad MLF : Six Programmable I/O Lines

• Operating Voltage : – 1.8 – 5.5V

• Speed Grade :

          – 0 – 4 MHz @ 1.8 – 5.5V

          – 0 – 10 MHz @ 2.7 – 5.5V

          – 0 – 20 MHz @ 4.5 – 5.5V

• Industrial Temperature Range

• Low Power Consumption

• Active Mode : -190 µA at 1.8 V and 1 MHz

• Idle Mode : -24 µA at 1.8 V and 1 MHz